• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Dead Bronco Help

broncokak

Bronco Guru
Joined
Jun 13, 2006
Messages
3,970
Well, I've never had any troubles with my EIF till today.

Worked on the rear axles and got everything put back together and was going to go for a test drive. The engine rolls over fine but will not fire.

I did leave the key on in the run position of about an hour by mistake. Not sure if that would do anything or not.

Pulled codes and got the usual ones but I also got 96, fuel pump primary circuit failure.

Checked fuel pump and it runs when you turn the key on. I have not been able to tell if it runs on crank at all. I put power to the pump all the time and that didn't help. I checked the fuel filter and its clean. Pulled the hose of the pump and turned the key on and the pump cycled and pumped fuel. I'm not sure of the pressure though.

I have power to the coil with the key on.

I have power to the TFI with the key on.

I could not tell if I had any spark while turning the engine over. I was out side in the bright sun trying to turn the key and watch to see if there was any spark.

My voltage is at about 10.5 volts from cranking the engine over. I need to put the battery charger on it.

I have an RJM Harness and all the fuses are good and I moved the relays all around to see if one was dead. Didn't make a difference.

This is all I have had time to check so far. Anything I should look for?

The truck ran fine Yesterday.

Thanks
 

tasker

Contributor
all knowing of nothing
Joined
Jun 2, 2006
Messages
21,707
Loc.
NH
INERTIA switch tripped or bad connector? pump should not run at all but just throwing it out there....
 

NYLES

Bronco Guru
Joined
Aug 13, 2004
Messages
9,846
Id charge batt or try n jump it, and check for spark. lil module thing on dizzy usaully goes after they warm but......I done replaced one and they go for just the sake a goin bad.

Grab a wire turn it over youll know it its firin, out in bright sun waht kinda excuse is that???
 

NYLES

Bronco Guru
Joined
Aug 13, 2004
Messages
9,846
INERTIA switch tripped or bad connector? pump should not run at all but just throwing it out there....

I forgot bout that tasker but like you said no fuel till its reset
 

NYLES

Bronco Guru
Joined
Aug 13, 2004
Messages
9,846
Mine would not crank at OCBR couple years back voltage at battery was 11
 
OP
OP
broncokak

broncokak

Bronco Guru
Joined
Jun 13, 2006
Messages
3,970
INERTIA switch is fine, was getting power in and out of it with the test light and the pump was cycling when you first turn the key on.

Hmmm, maybe my arms are long enough to turn the key and hold onto a plug wire...:eek:

Why do I have the feeling Nyles has done this before? ;D
 

NYLES

Bronco Guru
Joined
Aug 13, 2004
Messages
9,846
you gonna check n see if its firing er talk about it? itll only bite ya once and the tigher you hold it the better!


"DO NOT STICK YA TONGUE TO IT!" .........watch this gets em every time!
 

NYLES

Bronco Guru
Joined
Aug 13, 2004
Messages
9,846
oh you got a neutral safety switch? i use to have to run my shifter through the gears and back to park sometimes to start but that should kill everything keep searchin
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
What's the fuel pressure? That and verifying spark or not will tell you everything.
 

EFI Guy

TheEFIguy@gmail
Joined
Apr 14, 2013
Messages
1,168
Loc.
BFE
I would want to know fuel pressure first as well.

I'll share a little pro tip with you as well:

When checking for spark via the NYLES method, it would be best to provide a path to ground of your choice. Having your twig and giggle berries provide that path through the fender is not highly recommended.
 
OP
OP
broncokak

broncokak

Bronco Guru
Joined
Jun 13, 2006
Messages
3,970
OK, fuel pressure you will have. When I get out of work I'll dig around for the tester. Sad thing is I know right where it was in my old garage. :p
 
OP
OP
broncokak

broncokak

Bronco Guru
Joined
Jun 13, 2006
Messages
3,970
Oh, I'm hoping this is all it is. I'll hook the charger to it while I'm looking for the pressure tester tonigh.
 

Arikilen

Full Member
Joined
May 4, 2005
Messages
210
Loc.
Clovis, CA
Gremlins like this are a pain to work out. The good news is it will be one of three things; fire, oxygen or fuel. Since you hear the fuel pump priming when you turn on the key it has a high probability of working. I assume that oxygen isn't likely a problem, but have you verified your air cleaner is clean? That leaves spark as the most likely culprit.

Spark is the pain, the list affecting it is quite long. A few of the items are easily tested - like the coil, others are not, like the TFI Module. The TFI module is a fickle beast that I have just accepted as a required spare part.

Good luck, keep us up to date on your progress.
 

NYLES

Bronco Guru
Joined
Aug 13, 2004
Messages
9,846
ok dude I done got off work goofed off went fishin came home....n we still aint got a spark report.....she aint gonna crank w/o no fire! damn its tomorrow already!!!!
 
OP
OP
broncokak

broncokak

Bronco Guru
Joined
Jun 13, 2006
Messages
3,970
Ok, I, ran out of spark last night...got up with the sun and got at it. Got the battery charged to 13.5 volts and I would definitely say I have no spark. Still can't find my fuel pressure tester either.
 
Top