• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

200 6cyl to a np435?

Webster84

New Member
Joined
Jul 28, 2013
Messages
12
I'm wanting to put a np 435 on my 6cyl bronco. Was wondering if it will bolt up and has anyone tried this.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Yes it will bolt up but the only adapter availible will make it V8 lenght so you may need to do some crossmember moving and driveshaft mods.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
Yes it will bolt up but the only adapter availible will make it V8 lenght so you may need to do some crossmember moving and driveshaft mods.

Correct.

Since you have an I6 transmission extension you can get away with the adaptor block that bolts between the NP435 and the I6 tail housing.

Ford did a really good job in keeping the transmission to bellhousing pattern the same in from the mid 60's to the mid 80's (for the most part anyway). So you keep the I6 bellhousing, flywheel, clutch, etc. The 435 just plugs into the bellhousing that the 3-speed was attached to.

Length is the only catch with the I6. Since the I6 is longer then the V8, the bellhousing is located further back then the typical V8 location. So this pushes the rest of the drivetrain (transmission, transfer case, crossmember) back as well. This isn't that big of a deal, just measure for your fit and don't go off generic instructions for cutting a hole in the floor. Move the transfer case shifter hole to match.

The bummer part is with a V8 you don't have to move the crossmember, change driveshafts, move the transfer case shifter hole. But you have to go through that extra work with the I6
 
Top