• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Fuel Gauge Selector Help

Hoyt

New Member
Joined
Aug 4, 2014
Messages
14
My selector switch is lighting up a tester, but not reading the fuel amount. Before I climb under to investigate, what should I be looking for?
 

70_Steve

Old Guy
Joined
Dec 13, 2002
Messages
8,317
My selector switch is lighting up a tester,
I don't know what that means...

Power to the fuel level, oil pressure and water temp gauges comes from an Instrument Voltage Regulator (IVR) mounted on the back of the instrument cluster. The output of the (stock) IVR is a pulsed voltage, pulsing at something close to two pulses per second. That output of the IVR is daisy-chained to one side of the three gauges. The other side of the gauges is wired to the respective sending unit. The sending units vary resistance, with 73 ohms being 0% of scale, and 10 ohms being 100% of scale.

If any of those three gauges work, then the IVR is OK.

In the case of a Bronco with two fuel tanks, each with a sending unit, the "other" side of the fuel level gauge is wired to one of the Common terminals of a double pole double throw switch. The normally open and normally closed terminals of that half of the switch are connected to each of the two sendign units. The other side of the sending units are connected to frame ground.
 
OP
OP
H

Hoyt

New Member
Joined
Aug 4, 2014
Messages
14
I don't know what that means...

Power to the fuel level, oil pressure and water temp gauges comes from an Instrument Voltage Regulator (IVR) mounted on the back of the instrument cluster. The output of the (stock) IVR is a pulsed voltage, pulsing at something close to two pulses per second. That output of the IVR is daisy-chained to one side of the three gauges. The other side of the gauges is wired to the respective sending unit. The sending units vary resistance, with 73 ohms being 0% of scale, and 10 ohms being 100% of scale.

If any of those three gauges work, then the IVR is OK.

In the case of a Bronco with two fuel tanks, each with a sending unit, the "other" side of the fuel level gauge is wired to one of the Common terminals of a double pole double throw switch. The normally open and normally closed terminals of that half of the switch are connected to each of the two sendign units. The other side of the sending units are connected to frame ground.
Thanks, the double pole throw switch is what I was talking about. I'll have to check the tanks and grounds.
 

67RT

Bronco Guru
Joined
Jan 17, 2014
Messages
1,308
Pull the switch and test per earlier thread. Search the site. I was able to determine mine was open. Testing resistance across tabs on back. Depending where switch is there should be infinite res. across two prongs and zero across others. Move switch and in changes.
You can pull wires coming from tanks to the switch and touch to gauge wire and see what u get.
Don't toss switch if it tests bad. I took mine apart, cleaned copper and put back together and it is all good. Be careful as there are little check balls and springs. Take apart over t a plastic bin or something if it comes down to that..
Good luck. There is a great thread here. Search for it. I am on iPad and can't get it.
 
Top