• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

C4 shifting problems

OP
OP
Lunar-tic

Lunar-tic

Sr. Member
Joined
Sep 28, 2009
Messages
629
Loc.
Brentsville
UPDATE: Got my transmission rebuilt by County Transmissions in Vienna, VA. I knew I was in the right shop when the guy looks in my trunk and says "that's a Bronco C4." When I picked it up the guy says, "was that thing in the bottom of a pond?" Lots of rust still in it even though I paid good money to have it rebuilt in 2010 by what I thought was a reputable shop. The tech said he replaced anything that was rusty in addition to the usual rebuild. I also had a them add a B&M deep pan. I got it put back in over the weekend and it works perfectly and......no leaks so far, knock on wood. One question, I with the deep pan and an external Derale cooler (in addition to the radiator cooler), I am figuring ~12 quarts. Does that sound about right?

P.S. The guys at County Transmissions are awesome, I would give them return business. And my transmission now has a 24 month warranty.
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
12 should be close. Don't let it hit the full mark unless it's really hot or it will puke when it does get hot.
 

clarkaw1

Full Member
Joined
Aug 19, 2009
Messages
159
Loc.
Waterford, Michigan
There are 2 seals inside the direct clutch drum. The outer piston seal is easy to see and replace. The inner hub seal is difficult to see and difficult to replace correctly. It's a square cut seal that can roll easily when putting it in. I suspect that inner seal either wasn't replaced or it was done incorrectly.

Wiperwolf: You recently answer my trans question that has the start of this same problem.
If my memory is correct, there's a piston plate that goes in first in this drum. What trick do you use to insure you don't roll or cut this seal when installing it?
I'm going to rebuilt it as soon as the $$$ is right. I think I know the answer to my next question to you but lol, Its a fairly new rebuild, can I just replace the seals only?
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Wiperwolf: You recently answer my trans question that has the start of this same problem.
If my memory is correct, there's a piston plate that goes in first in this drum. What trick do you use to insure you don't roll or cut this seal when installing it?
I'm going to rebuilt it as soon as the $$$ is right. I think I know the answer to my next question to you but lol, Its a fairly new rebuild, can I just replace the seals only?

Lube the ring and slowly walk it around the inner stub of the drum making sure it doesn't roll on it's side. A pick can help if you have big fingers. Once it gets walked down to the slot and the inside of the ring goes in it won't roll.

I'd replace both seals and use the clutches over if there's no sign of overheating.
 

clarkaw1

Full Member
Joined
Aug 19, 2009
Messages
159
Loc.
Waterford, Michigan
Lube the ring and slowly walk it around the inner stub of the drum making sure it doesn't roll on it's side. A pick can help if you have big fingers. Once it gets walked down to the slot and the inside of the ring goes in it won't roll.

I'd replace both seals and use the clutches over if there's no sign of overheating.

Thank you as always!
 
Top