• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Fitech, Explorer Serp, and Edelbrock Intake - Temp Sensor Question

redwards69

Sr. Member
Joined
Dec 8, 2014
Messages
367
Loc.
Double Oak, TX
For those who have installed the Fitech system, have the Explorer or Mustang Serp setup, AND perhaps have an Edelbrock 2121 intake, how have you solved for the temp sensor issue?

Obviously the Fitech needs the digital sensor it comes with, but I still want the analog gauge in the dash to work. Where are you mounting a second sensor?
 

BUCKWILD

Sr. Member
Joined
Jun 20, 2016
Messages
355
Loc.
Butte county
tstat housing, you can buy one with a plug in it or most have the boss in then just need to be drilled and taped
 

Crush

Contributor
Bronco Guru
Joined
May 30, 2007
Messages
3,463
Loc.
Greenbottom, WV
there are two places on the mustang intake. there is the one in the heater tube and there is one in the intake just like the carbed engines have
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
Living in AZ I didn't need a strong heater. So I pulled heater water off the back of the intake manifold. It isn't as hot there as it has only had the block to heat it and not the heads that put most of the heat into the coolant. Works good enough for where I live and how I use it.

The computer and gauge sending units at the front of the intake. Reading the heat coming off the heads.

Not a fan of the thermostat housing. Reads low as the engine warms up
 

rmcmillan

Contributor
New Member
Joined
Oct 1, 2014
Messages
25
I'm in the process of installing fitech with Explorer serpentine front dress.
I am using an Elderbrock Performer 7121 due to the heads that I am running with my 302 install. I installed mine right behind the thermostat housing (drilled & tapped). I will be using a Classis Instruments digital Odometer water temp gauge along with the Fitech water temp gauge. See before and after photos.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
There is a block drain spot you could use and I have.

That is nearly the coldest spot on the engine. The cold water drawn off the radiator is pushed into the block first. The drain you speak of is at the bottom of the cylinders, the fire happens at the top.

I would not expect accurate readings in that spot.
 

pcf_mark

Bronco Guru
Joined
Jun 11, 2010
Messages
3,697
Anyone have a p/n for the tstat housing with a plug?

When I bought my "68 Bronco" replacement from Advance it came with a hole and plug even though my original did not. The 2000 Explorer replacement I bought later when I did my serp conversion did not have the plug but it was drilled most of the way through. I just drilled all the way and tapped it.
 

Mikesimp70

Full Member
Joined
Jun 20, 2017
Messages
341
When I bought my "68 Bronco" replacement from Advance it came with a hole and plug even though my original did not. The 2000 Explorer replacement I bought later when I did my serp conversion did not have the plug but it was drilled most of the way through. I just drilled all the way and tapped it.

Solved!

Picked up a housing with the port. Thanks!
 
Top