ObscureMachine
Seatbelt Orifice Officer
I'll be putting together a new plan for building my bronco soon, but I have a question about getting to bare metal on the interior.
Going to have passenger floor pan installed. Then remove all seats but driver's and remove roll cage. Then get rid of the Denno-Liner (evil undercoating / liner / crap that ButtStank did) - by blasting or dipping of scraping of chemically. Then "Line-x" the floor of the entire tub, reinstall seats and new family cage.
1. To get to bare metal, should I media blast? If so, what kind of media?
B. Is it ridiculous to save money and wire brush the entire floor (wire brush on grinder or drill)?
Q. After I get it to bare metal, what should I do (primer? paint?) to get it ready for Line-X?
Thanks! Jim
Going to have passenger floor pan installed. Then remove all seats but driver's and remove roll cage. Then get rid of the Denno-Liner (evil undercoating / liner / crap that ButtStank did) - by blasting or dipping of scraping of chemically. Then "Line-x" the floor of the entire tub, reinstall seats and new family cage.
1. To get to bare metal, should I media blast? If so, what kind of media?
B. Is it ridiculous to save money and wire brush the entire floor (wire brush on grinder or drill)?
Q. After I get it to bare metal, what should I do (primer? paint?) to get it ready for Line-X?
Thanks! Jim











