• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Rear main bearing?

surfer-b

Contributor
Bronco Guru
Joined
Sep 7, 2006
Messages
3,013
From the looks of the crank I would bet it needs to be turned, unless you just want to get by for some time while you build/buy a new engine. When the rear main seal starts to leak that's usually a good sign the mains are getting worn down, it allows the cranks to move and wear out the main seals
 
OP
OP
D

diggs00

Sr. Member
Joined
Jul 8, 2016
Messages
355
From the looks of the crank I would bet it needs to be turned, unless you just want to get by for some time while you build/buy a new engine. When the rear main seal starts to leak that's usually a good sign the mains are getting worn down, it allows the cranks to move and wear out the main seals


There was not a rear main seal leak, just wanted to replace since i had the engine in the stand.
Plan is to get it turned, just need to find a shop in Austin TX area. In reinstalling the new crank, how important is it to make sure the piston rods meet up in same place they did before. This is all new to me so excuse my stupid questions.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
Evaluate everything. Are the rings good? Does it use oil? Timing chain? It may be ready for a full rebuild.
 

unimogger

Full Member
Joined
Aug 7, 2019
Messages
214
Loc.
Philthadelphia
Waste of money getting it turned and not pulling it all the way down for a full inspection and cleaning. The dirt and grit that caused the scoring is hiding all throughout the block and will wipe out new parts quickly if you don’t get everything cleaned properly
 

Apogee

Contributor
Bronco Guru
Joined
Nov 26, 2005
Messages
6,348
Loc.
Tangent, OR
It's on the stand, the pan is off and the crank is out...this would be the time to do something if you're going to do it. I'd finish the tear down and do a full inspection on the block, heads and components and then make an informed decision as how best to move forward. Find a reputable automotive machine shop to help with inspection, and they can then provide a quote for the various things that will invariably need to be done.

Or just do a crate motor and be done with it...
 

blubuckaroo

Grease Monkey
Joined
Jun 11, 2007
Messages
11,796
Loc.
Ridgefield WA
I've seen bearing inserts, with a few scratches in the Babbitt, that lasted for many thousand more miles. In your case though, the Babbitt plating is gone. The crank surface is damaged to the point that resurfacing is necessary.

How you go about the repair depends on how you plan to use this vehicle, your budget, and the condition of the other engine components. Sure, it's nice to be able to just throw a bunch of money at it and replace/rebuild the motor, but if your use is only occasional, and have more time than money, sure, you can fix just the crank & bearings. It certainly wouldn't be the first time an engine got a ring and bearing job.
 
Top