• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Bouncing speedometer

jhill52

Jr. Member
Joined
Dec 22, 2012
Messages
127
I just got my Bronco back on the road after several years of repairs. The speedometer does not hold steady but jumps +/- 10 mph. It worked fine before it sat. Do you think the cable is just dry and needs to be lubed. If so what is the best way to lube it. It is a basically stock 71 wagon.
 

73azbronco

Contributor
Bronco Guru
Joined
Nov 11, 2007
Messages
8,782
Might just be easier to replace. Might already be too damaged.

If you want to lube might try some bike chain dry lube like Inox or triflow, but I bet it won't help very long. And by try you need to remove instrument cluster and unscrew speedo cable to lube from top. You might be able to remove cable without pulling cluster, but I doubt it.
 

Jfryjfry

Sr. Member
Joined
Aug 28, 2017
Messages
503
I installed my cable with the cluster in place, so it’s likely possible to do it. Unless it is siezed up or too tight and not enough room for pliers
 

Madgyver

Bronco Madman
Joined
Jul 30, 2001
Messages
15,030
For me it was a bad speedo cable. Replaced it with a new one from one of our vendors and it's good.
 

SteveL

Huge chevy guy
Joined
Jun 24, 2001
Messages
11,969
Loc.
Hawthorne ca
I never really worried about it. Out here you just go with the flow whether its 5 or 85mph. Usually closer to 5.
 

Slowleak

Bronco Guru
Joined
Sep 12, 2013
Messages
4,013
Loc.
Georgia
Do you think the cable is just dry and needs to be lubed. If so what is the best way to lube it.


Reach up behind the speedo and unscrew the cable. Pull the center part out and wipe it clean with a rag. Lube it with cable lube from any parts store, I use CableEase from Ace Hardware. Reinsert it into the housing. You may have to rotate it to get it to seat when it bottoms out. Screw it back onto the speedo but don’t over-tighten it.

An easy way to get to the back of the speedo cluster is to take out the air box in the cowl and get to it from under the hood. You can also unhook it and pull it back thru the firewall...
 
Last edited:
Top