jerrybromley
Full Member
- Joined
- Sep 17, 2018
- Messages
- 344
Well I did it
I bought a hole punch set (cheapy) and used the 2 inch conduit punch to make the hole . I found that my step bit worked really well to put the original hole for the punch bolt.
In order to locate the holes for the screws that hold the neck in place , I made a template from cardboard so that it was tight on the neck .Then punched holes on the cardboard where the holes were and used a felt marker to put a match mark on both the template and the neck. I then removed the template and put the neck in place. Then I placed the template on the outside of the Bronco and over the part of the neck sticking out. Then drilled my holes for the screws.
I am pleased with the install and the hole size on the punch was very close ..just a little large. Now I can stop obsessing over that stupid hole ;D;D
I bought a hole punch set (cheapy) and used the 2 inch conduit punch to make the hole . I found that my step bit worked really well to put the original hole for the punch bolt.
In order to locate the holes for the screws that hold the neck in place , I made a template from cardboard so that it was tight on the neck .Then punched holes on the cardboard where the holes were and used a felt marker to put a match mark on both the template and the neck. I then removed the template and put the neck in place. Then I placed the template on the outside of the Bronco and over the part of the neck sticking out. Then drilled my holes for the screws.
I am pleased with the install and the hole size on the punch was very close ..just a little large. Now I can stop obsessing over that stupid hole ;D;D











