I recently decided to get rid of my Front Bench with a rear seat combo, as it was way too difficult to get in and out of the back seat. That and I wanted headrests for safety in the event of getting rear-ended.
So I picked up a set of seats from Tom's. The Tom's seats look pretty good, and they provide the headrests I wanted... But they dont improve the rear seat access much at all. So I went to work on a solution.
I picked up a passenger seat base from a 1990 Extended Cab Ranger (from before the third door existed), the same as the mechanism in a 1990 Bronco II, like I used to have.
I then ground off the rivets holding the angled front mounts off, and removed those mounts.
I ordered the Passenger Seat Storage Cubby from Wild horses to give me a flat mounting surface for the seat bracket.
I took the slide mechanism provided by Tom's off of the seat. The Ranger bracket lined up with the forward mounting holes on the seat perfectly. I marked the seat where it needed to be drilled in the rear for the mount. Then drilled and tapped it.
Here it is installed:
Here it is with it tilted forward:
And here it is slid forward until the headrest hits the windshield:
A massive improvement in access to the rear seat!
It is a relatively straightforward adaptation. If any of you are looking for better rear seat access, I would encourage you to give this one a shot.
So I picked up a set of seats from Tom's. The Tom's seats look pretty good, and they provide the headrests I wanted... But they dont improve the rear seat access much at all. So I went to work on a solution.
I picked up a passenger seat base from a 1990 Extended Cab Ranger (from before the third door existed), the same as the mechanism in a 1990 Bronco II, like I used to have.
I then ground off the rivets holding the angled front mounts off, and removed those mounts.
I ordered the Passenger Seat Storage Cubby from Wild horses to give me a flat mounting surface for the seat bracket.
I took the slide mechanism provided by Tom's off of the seat. The Ranger bracket lined up with the forward mounting holes on the seat perfectly. I marked the seat where it needed to be drilled in the rear for the mount. Then drilled and tapped it.
Here it is installed:
Here it is with it tilted forward:
And here it is slid forward until the headrest hits the windshield:
A massive improvement in access to the rear seat!
It is a relatively straightforward adaptation. If any of you are looking for better rear seat access, I would encourage you to give this one a shot.











