Painless wiring harness install question

[SeaVee]

What are you guys doing with your unused wires that are in the harness. Specifically the #970, #900,#957, since I am using a Pertronix Flamethrower billet distributor and coil. Did you took them under the behind the firewall? Or just trim them back. I won’t need them but for future owners should I save them?
TIA!

 

[Brush Hog]

I bunched mine up wrapped a big piece of loom around them and velco strapped them under the dash. Was a tight fit but wanted to save them. Velcro ties makes it easy to undo and pull out a wire if and when I add an accessory.

 

[Otis Campbell]

I bunched mine up wrapped a big piece of loom around them and velco strapped them under the dash. Was a tight fit but wanted to save them. Velcro ties makes it easy to undo and pull out a wire if and when I add an accessory.

This is essentially what I did too.

 

[SeaVee]

Thanks!

 

[904Bronco]

Terminate them in a weather pack plug. save the extra wire for future accessories.
If they have individual fuses, that don't affect other circuits, remove them from the fuse panel.