Search results

looking to add a 2" receiver without spending over 350.00 from Toms (shipped).....I don't have a welder so a bolt on option would be best.....Just to clarify, this receiver will only be for moving garbage bins up and down my driveway so very little weight and in no way ever be used to actually...

exactly what the title says!! Looking for a stock, stamped steel 2 groove, 3 bolt crank pulley. Diameter has to be 6.5" or smaller. 6.625 hits the water pump pulley so that will not work :). Grooves need to be 7/16" wide. Thanks!!!

Looking for a hard top with glass within a couple hundred miles from SF Bay Area.

looking for stock front shaft.

picking up some Outlaw 1 AR61 15x8 wheels. They have a 3.75 backspace and -19 offset. I now the 3.75 backspace will work but the -19 offset has me confused and not discussed a lot. Will I be ok with these? I know that I'm limited to tires with the 15" rims but I like the look of the 15's and...

having weird issue with rear brakes. I changed out my bake shoes, wheel cylinders and put a new spring kit in it since it's been close to 25 years with these shoes. I have a 70 with 11" x 1 3/4" rear brake shoes. The brake job went as well as any I've done in the past until it was time to...

Just got a set of rear drums in. Problem is there is no opening to adjust! It looks like the hole was not punched out or it's a knock out for me to do. Well I've tried it with a punch and up to a 3 lb hammer with no luck. Once again, getting parts that aren't right from the get go. I wouldn't be...

Looking at adding a 65 mustang to my herd and curious what rear end this may be.......

I'm looking for a good, solid drivers door. No dents or rot. I'm happy to buy a set if they're both in great shape shape just to get the drivers. In SF Bay Area

Silly question but what is this bolt for on my drivers side knuckle? It's not tight and the passenger side has the hole but no bolt. 30 years and never noticed it before.....

looking for a good gauge cluster.

Pick up only in Fremont CA.

So I know that gaps are a huge pain to get close and were never that great from the factory. I've spent many hours and several methods over years to get the gaps right on my drivers side door. About ten years ago I bought some stainless lift off hinges and while I was able to get the passenger...

Well it only to 21 years, 1 month and 10 days to get to a thousand post....... On this site daily, enjoying all the post and pics and have learned a ton from the great folks on this site. Thanks go out to John and all of you all who make this such a great place to hang out!

Looking for drivers front fender in good shape....looking for an original piece and not a repop... thx!

need a little help identifying this PS pump. got it in a quick ratio kit from either WH or Toms 20 years ago and needing to replace the pump.

So I've been having weird issues with my clutch.....it engages and releases fine but after a couple miles of freeway driving, if I push the clutch in, it feels like i's binding at the very top of the stroke. It still releases when pushed to the floor just fine. The only time it does this is...

Wanting to convert to a c4 from my current manual 3 speed column shift. Looking for all parts needed. Can pick up in Nor Cal area.

Some items I will bring if there's interest...... Stock valve covers - 20.00 Stock 2 barrel manifold - 20.00 Stock 302 heads around 30k miles - 25.00 Stock 3 speed trans (RAT) no issues when pulled - 25.00 Stock aux tank with sender (used and sender worked when pulled and no leaks in the tank)...

is this event still going to happen?? It's listed on their website but the link to register is dead.......