Search results

I tightened up everything I could in the column. The bearings seem ok. I made sure the nuts under the steering wheel were tight as well. There is still a little up and down give but it is not as bad. On the downside, now my turn signals no longer work. I looked at the turn signal switch and...

I was looking at the listed bronco clubs and noticed there is nothing in my area of the country. I need a club that would cover the section from say St. Louis to Indianapolis to Louisville to Nashville. Is there any such club out there? How would someone go about setting up such a club...

I need help. I think one of my bearings in my 1969 steering column went out. The steering wheel now has a lot of slop and will move around. The column itself is tight but the inner shaft moves. Under the hood I can pull the inner shaft back and forth. I cannot find anything on how to...

Centech I finally got in touch with Centech and I am glad I did. Jim is a genius and a nice guy. He was very patient and walked me through troubleshooting step by step. He figured it out. My problem was a faulty hazard switch. I unplugged that and now everything works as it should! What a...

God... I don't want to tear apart that column and definitely don't want to replace that switch!!!!

I tried to contact them but they don't answer the phone. I also Sent a message on their form but they didn't reply. The tech guy at Dakota was an ***hole and didn't want to be bothered with my trivial problem. The biggest help was from a tech guy from Tom's.

Yes but I had to replace the signal switch with one from Tom's.

I have installed a 1966-1977 Ford Bronco Centech Wiring Kit from Jeff's. I have a 1969 Bronco. Mostly everything has gone well. I also installed a Dakota Digital dash. I have a gremlin that the tech guys at Dakota and Jeff's can't figure out. When I turn on the Hazard switch, the rears work...

Thanks everyone for the replies. I am only carrying it for emergencies and flats. I wouldn't ever use it for maintenance. I also have a farm and it will be handy to have there as well. I think I am going to drill the roll bar and bolt it there atop the wheel well. I'll post pics when I get...

Helpful.... I wasn't sure of the most used sizes. I bought a small multipurpose tool kit.

Kids!.......Used on farms up until the 1980's. Pretty similar to rebar tie wire.8-);D

Doesn't do me a hell of a lot of good when I have a flat or am hung up out in the boonies.

What is the best way to mount a 48" Hi-lift jack in the bed of a 69 Bronco. I was thinking about fabing a mounting system to go on the lip of the bed. Any ideas and instructions?

I once towed a seeder with it. It whipped me all over the road, scared me to death and made my wife pee herself!:o

Hell, where do you even find baling wire anymore? Everyone around here bales in large round bales.

I have a small under the hood tool box in place of a side vent. We are getting ready to drive to the Super Celebration and I wanted to stock the box with the best option of roadside equipment. I am going to put in tire plug kit, Flat head, phillips, crescent wrench, wire cutters, silicone. I...

Thanks guys I'll go ahead and get one with the seal kit, motor and cage. Winter isn't over here. We have another winter storm on the way!

I have a 69. Nothing has been done to the heating system. I am going to reseal the box and replace the vent hoses. I am also going to upgrade the motor and cage. Do I need to replace the core or just flush it? There doesn't seem to be anything wrong with it (not leaking or anything). I...

I made a classic Bronco Flickr group and started posting pics. If anyone is interested, here is the link. https://www.flickr.com/groups/classic_broncos/

That is my next project.