Search results

The seals in the C-4 will tend to dry out if let to sit that long without running. Try and let the rig warm up for quite awhile and you should be able to get it to move.

Needa, I hear 'ya on that, but there is that cash thing.....I still haven't decided on which route I'm going to take on that yet(all new or used spindles/backing plates+ new stuff) My rig was in storage for over 10 years when I bought it and I've slowly been getting all the safety issues taken...

Nope, no O'reileys out here, just NAPA, Autozone, Kragen, Wild Horses, etc...

Thanks guys!!

I've currently got a Drum/Drum setup on my '74 and the master cylinder is starting to leak slightly. I plan on doing a front disc conversion in the near future and I'm wondering if a Disc/Drum master will work with my Drum/Drum setup until I do the swap? Basically, I don't want to have to buy...

How about Honda S2000 seats? Anybody use them?

I did it and it seems to work pretty well so far except the trans linkage binds a little. I still havent looked into it too deeply yet as why that's going on cuz I'm all over the map fixing other little stuff. I think I saw a write up over at Broncofix.com. I got a lower shaft from WH and had...

Mine is a 74 with an 8 = Sandpiper Yellow. Original and still looks decent

Thanks guys, I'll keep searching or just buy the new spindles

I was curious if anyone knows if the required chevy parts for the front disc swap would work from an '82 4x4 pickup? I've searched and I know what WILL work, and the only reason I ask is I've got access to good parts for free and if they'll work I'll snag 'em.

I'd like a quote on the Moab's (neoprene) with brackets. Thanks!!

That looks like a good find. I'm In a similar boat as I picked up a '74 two months ago that has been sitting in a garage for about 10+ yrs. Without the efi motor though.....btw, based on the fact it appears to be mass air, I'd say it's probably from an 88-93 vintage mustang. There should be a...

ttt...anyone? Bueller?

I recently swapped the auto column in my '74 to a tilt from a '79 van. Welded on the old mount and got it in place. The problem is that no matter how I try to adjust the linkage I cant get the thing to shift smoothly. The linkage seems to bind especially from D on down. For those that have...

I'm working on the install of my tilt column which I got from a 79 van. I'm getting the stock EB linkage to work ok after a little tweak here and there but it's not quite right and the indicator won't line up properly especially in 1 and 2. Should I be using a different linkage? BTW, the one...

It seems I've possibly misplaced the two steering column mount bolts for under the dash. The ones I thought were correct start fine, but get VERY tight, but turnable with a wrench, after a couple turns. I just don't want to destroy the nuts in the dash if these are incorrect. Anybody know...

Found one thanks guys

Xlent thanks

Hi all, new to this forum and I have a question. I recently purchased a '74 and I need a steering column. I was searching posts and came across the '78/'79 E/F series tilt swap. I've never heard of the E series in a truck. Would that designate econoline van? I just want to make sure I get...

Hi, I'm looking for a good useable AUTO steering column for a '74. Any help appreciated. Thanks, Will