Search results

Get now for that winter project!

Have any pics?

Could you post pics?

Still available? Been looking for one like this to fix up for a dune cruiser.

Back to the top!

Back to the top!

I have a brand new set of complete body sides built by Bronco Design. The rear panels are their +12" which are 12" longer than factory. They are 3 piece...rear panel, door insert, and fender. I bought these to build a race truck that I have decided to part out. Thanks for looking.

Just a update.....went to the DNR volunteer training this past Tues and want to correct my previous post. The DNR and volunteer workers can only "advise" that tires be aired down to proper levels to insure sufficient traction on sand surface. However, you will be turned out of the dune ready...

Frenchy, sorry for slow reply but answer to your question is you have to be aired down ready to go on the dunes. You can do this at the Welcome Center (formerly voucher center) if you are not comfortable driving around on low tires. FWIT I have talked it over with my tire guy (25+ yrs exp) about...

Regarding stickers......you guys are correct in that anywhere that sells hunting licenses also can print off ORV's. At SL you can get them at the Welcome Center (old voucher center), the point store, and B&L Motorsports (old Appletree across from entrance). I bought mine at B&L and they also had...

Is an impressive pile of parts and 2 frame rails.....not yet worthy of any pics. As soon as I get the rails welded up I will get some snap shots on here.

Yes they are still open....Corey got a hold of me a week ago and said my Skins are completed and just need trimmed. Also said that they are in the process of moving to a larger shop!

This project has taken a crazy turn. I am building (trying) a clone to Maui Matt's bronco skinned buggy. I have accumulated most parts....skins should be here in a couple weeks from Bronco designs, have powerglide, full width HP 44, 14" kings, Overtime CNC straight through transfer case, sold my...

What you want for the grill? Is it steel?

Millwright at Chrysler

Jefe, no build thread yet. I just got my tubing bender this week. Have frame and cage designed but not to spec. Now I need to plug in my true numbers and work with the 4 link calculator and get everything where it will work. Sorry for hijack OP?:? Will start a build thread soon.

Just in the beginning stages of my build and motor arrived 2 weeks ago but when finished should look like this!

I was going to try and stick with the stock frame width but I think I would benefit more by getting it as wide as possible. My reasoning for keeping stock width was I thought it would be easier to mount the rear shocks on the lower control arm outside the frame but as Yeller stated doing it this...

Thanks for the replies guys. As far as the 4 link goes, should I try to keep the pivot points as close to the CV joints as possible? This thing will be a dune and ice cream runner only......no rocks. Or should I try to setup using the 4 link calculators on the internet?