• Be EXTREMELY cautious if someone offers to buy your Bronco for more than your asking price and sight unseen. ESPECIALLY if the buyer is overseas. It's probably a scam.

    Discuss it more here:
    http://classicbroncos.com/forums/showthread.php?p=514932
  • The Classifieds forum is a place to buy and sell, not an open forum for people to give their opinions on Bronco values. Unless the seller specifically asks for help on pricing, please don't critique quality or asking price. If you're not interested then move on. - Thanks!
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

SOLD 1973 Bronco with half cab

Status
Not open for further replies.

thegreatjustino

Contributor
Red Head Grease Monkey
Joined
Jan 23, 2002
Messages
16,291
Loc.
Stockton, CA
1973 Bronco for sale.

U15 wagon style with half cab top.

Half cab has been modified with a sliding window in the back.

Bulkhead is aftermarket -- it goes straight down into the bed from the half cab instead of angling in like a factory bulkhead. This gives you about a foot of storage room behind the seats in the cab.

Groovy wooden dash overlay

Bronco II high back seats

Three gas tanks -- one main, two side tanks. All three are metal tanks

Rear traction bars

Rear 9" (small bearing) with recently rebuilt third member (open carrier with 3.50 gears)

Front Dana 44 with disc brakes -- Ford knuckles out conversion

302 V8 with Edelbrock performer intake & Carter 4bbl carb

Flow Kooler water pump

Power steering with Saginaw pump

Mickey Thompson aluminum valve covers

Stock three speed transmission with Hurst floor shift conversion

Smooth shift collar on steering column

Aftermarket temperature, oil pressure, and battery gauges (need to be hooked up)

Entire Bronco has been re-wired at some point

Electric fuel pump

BC Broncos two into one exhaust system

Dual shocks in front

2" suspension lift & 1" body lift


Known issues:
Brakes need to be bled
Driver door is very difficult to open from the outside
Gas gauge does not work
Side tanks can't be used due to broken switching valve
Tunnel cover needs to be installed
Front floor pans are rusty and will need to be replaced at some point
Tailgate has rust bubbling at the bottom below the license plate
Battery hold down needs to be installed
Air cleaner needs to be installed
Rear fuel filter needs to be relocated
Front transfer case yoke is incorrect, so front driveshaft is not installed

I am in the process of addressing some of these issues. As they are taken care of, they will be deleted from the "to do" list.

Note that while in good running condition and fairly rust free (see comment on floor pans above) this Bronco has been taken off road significantly, and because of that, several of the panels are dented. Over the years, they have been smoothed out in places with body filler, but some of that filler has cracked out, and other damage has been done on other wheeling trips. This is a Bronco that was used for what it was built for, and is in corresponding condition.

l.jpg


l.jpg


l.jpg


l.jpg


l.jpg


l.jpg


l.jpg


l.jpg


l.jpg


l.jpg


l.jpg


l.jpg


l.jpg


l.jpg
 
Last edited:
Status
Not open for further replies.
Top