• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

1999 Exploder Downpipe Size?

spatacuulous

Full Member
Joined
Mar 21, 2005
Messages
169
Loc.
philadelphia
Quick one. Just ordered a downpipe set off of EbAy for my 1999 Ford Explorer 5.0 engine and they seem small. 2" is what I bought. Anybody know the correct size? I am running the OEM Exhaust manifold.
 

Attachments

  • STP60675.jpg
    STP60675.jpg
    144 KB · Views: 35
  • STP60677.jpg
    STP60677.jpg
    119 KB · Views: 47

Nobody

Bronco Guru
Joined
Feb 15, 2005
Messages
1,215
Loc.
Stanwood
2" sounds right. My t-bird 5.0L HO had 2" head pipes. According to the exhaust theory I've read, 2" should be plenty.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
Looks like Exploder by the pics. And though I agree that 2" is probably stock, it sure looks like a small'ish fit without the clamp in place.

Did you make any mods to the engine? Such as a cam or any other high-performance goodies. If so, then you would have decent grounds for going up to 2 1/4" if they make it.
Either way, you'll be most likely be going bigger when you get down by the muffler anyway.
You going to be running a single or dual exhaust setup?

Paul
 
OP
OP
spatacuulous

spatacuulous

Full Member
Joined
Mar 21, 2005
Messages
169
Loc.
philadelphia
It's the original stock manifolds. I want to run a dual exhaust setup. Does dual sound better or add anything to the power?
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
That's an original Bronco manifold? Hmm, been awhile since I've seen one, but would have sworn it was a later piece like would have been from an Explorer.

Duals may or may not sound better. Depends on what you like. Sound is a very personal feeling.
Many think it's better and many don't think it matters.

Power, again, depends on how it's built and what components you use. You could get more power from a single if you're comparing a small dual to a large single. It's not just about flow always. Sometimes it's about "the tune".
If that's a stock EFI Explorer engine, you don't need maximum flow. You just need a properly sized system for your application. Bigger than stock is ok, but go too big and you'll end up with other issues.

I prefer a good breathing single nowadays.
I don't have a sound preference one way or the other. I don't need the flow of a well-designed dual system in a lower revving off-road/daily driver type truck engine (if you're planning on max hp at higher rpms all the time, go for it) and a single is WAY easier to route down the right side and out of the way of the fuel, brake and electrical sytem.
Yes, dual tips out the back still look cool. But I'm more than happy to lose the tip choices for a more convenient and better designed system overall.

Personal preference.

Paul
 

HoosierDaddy

Contributor
Bronco Guru
Joined
May 29, 2006
Messages
2,776
Just went from long tube headered duals to BC's headers and a single , love it. Still has a throaty , gutsy sound but is not loud.
 
Top