351 AOD with np205 questions

[Chris76bronco]

Running a 351 and AOD with a np205 do I have to have a body lift

 

[Broncobowsher]

Don't have to, but would make installation easier.
The 351 alone can be a tricky fit by itself, you need the right intake, carb, air cleaner. Easy to stack that engine to the point it won't fit under a stock height hood. The AOD will fit but the 205 may take a little floor massage.

 

[Chris76bronco]

351 is already in just going from the 3 speed manual to a AOD with a NP205

 

[hardwork]

I used a 2 inch body lift on mine. Made it much easier, my 205 is close to the floor boards. about a half inch clearance.

 

[Chris76bronco]

how does your 205 set compared to the frame im having issues the part of the transfer case where the mount goes to connect to the frame is at a weird angle???? it should be square with the frame and tried to rotate it down some then nothing lines up. NEED HELP

 

[pcf_mark]

The upper drivers side of the NP205 that is flat should be vertical if you clock like factory. I do not have a body lift and shoved mine all the way up in the tunnel until it hit the e-brake mounting bracket on the floor then lowered it about .25 for clearance. The drop side going to the front axle is a few inches below the frame. Hope that helps.