Ourobos
Bronco Guru
Due to circumstances beyond my control, I'm liquidating my project. I sold the bronco yesterday, and I have almost all the parts I had collected to start restoring it.
Freshly built 351w. 1992 block, new rings, bearings, oil pump, seals, gaskets, the works on the bottom end. Head studs. Heads are aluminum Pro-comps that have been cleaned up with .500" lift springs. Has Scorpion roller rockers, fabricated aluminum valve covers. Billet distributor. Has an expensive set of Crane hydraulic roller conversion link bar lifters. Cam is a Mustang HO cam advanced 4 degrees with an expensive timing set. Has an Edelbrock Performer knock off EFI intake. Fuel rails, 24# injectors that have just been restored with new screens, rings, and flow tested. Rear sump 5 quart pan. Comes with a 164 tooth 28oz SFI flexplate. Front accessories are explorer, balancer was just rebuilt and rebalanced by damper dudes. New water pump, good alternator and Explorer power steering pump. The engine is pretty much ready to drop in. $2,900 picked up in KY
1992 4x4 box and 1970s 4x2 box and Wild Horses seal kit to put the two together. Just spend a day and have a rock solid box - $250 for all of it
I have a few misc. things , a push bar (stock looking piece that bolts to bumperette location), older 2.5" lift kit, 2" body lift minus a few bolts (new). Will get pics shortly.
Brandon
270-287-7623
Freshly built 351w. 1992 block, new rings, bearings, oil pump, seals, gaskets, the works on the bottom end. Head studs. Heads are aluminum Pro-comps that have been cleaned up with .500" lift springs. Has Scorpion roller rockers, fabricated aluminum valve covers. Billet distributor. Has an expensive set of Crane hydraulic roller conversion link bar lifters. Cam is a Mustang HO cam advanced 4 degrees with an expensive timing set. Has an Edelbrock Performer knock off EFI intake. Fuel rails, 24# injectors that have just been restored with new screens, rings, and flow tested. Rear sump 5 quart pan. Comes with a 164 tooth 28oz SFI flexplate. Front accessories are explorer, balancer was just rebuilt and rebalanced by damper dudes. New water pump, good alternator and Explorer power steering pump. The engine is pretty much ready to drop in. $2,900 picked up in KY
1992 4x4 box and 1970s 4x2 box and Wild Horses seal kit to put the two together. Just spend a day and have a rock solid box - $250 for all of it
I have a few misc. things , a push bar (stock looking piece that bolts to bumperette location), older 2.5" lift kit, 2" body lift minus a few bolts (new). Will get pics shortly.
Brandon
270-287-7623
Last edited:











