• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

351W Camshaft Advice

stoker

Jr. Member
Joined
Aug 28, 2011
Messages
127
I am building a 351W to replace a tired 302 in a 73 EB. It is fitted with: Top-Loader 4-speed transmission, 4.11 ratio rear axle with 33” tires. Local engine shop is recommending an Elgin E-1790-P camshaft. Will be mostly street use with moderate off-road, nothing extreme.

Intake Lobe Lift: .303
Exhaust Lobe Lift: .303
Intake Duration @ .050”: 216 degrees
Ehaust Duration @ .050: 216 degrees

What are your opinions on these specs? Elgin describes this class of camshaft as follows:

Fair idle quality with lope. Good mid-range torque and response in 2400 - 3200 RPM range. Operating power range 2000 - 4800 RPM. Good fuel economy cam with correct equipment. Good choice for light towing. Compression 10.3 to 1 or less. Will work with stock or slightly modified engine, stock automatic or manual transmission.

Any advice appreciated.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
What heads are you running?

I am thinking the duration is a little long. .485" valve lift is OK.
 

rguest3

Bronco Guru
Joined
Dec 13, 2012
Messages
3,780
I think there are others out there that have much better cams with a more updated Cam profile. Comp Cams, Crane...

216 Duration at .050 is not very big at all for a 351w. Should be in the 1200 to 4800 rpm range and not a higher 2000-4800.

As calculated, the .485 lift may need new springs as well. I would like additional lift in a SBF too...... You can do better.

You have the 4-speed or the shop does??? If the shop does, ask if the Top Loader is a "Wide" or "Close" Ratio??? A Wide-ratio Toploader is OK with the additional torque of the 351w and your 4.11 gears. A Close-ratio would not work at all with the higher (lower number) 1st gear.
 

spap

Bronco Guru
Joined
Jan 2, 2010
Messages
2,642
A loopy idle on trails can get a little a little irritating
But it does sound good.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Should be a good choice for a 351 with 4.11 gears. Wouldnt worry much about to big of a cam offroad with the toploader you'll be in lowrange anyhow.
Personally I like dual pattern cams for small fords they tend to work a lot better especailly with stock type heads. single pattern cams like the one you picked are not quite as good. Also the cam you picked most likely will have a 302 firing order not a 351 firing order.
I also think there are better options out there Im not to big on comp cams, I like crane cams. But overall I think your in ok with that duration or slightly lower duration. Just make it a dual pattern meaning duration on intake and exhuast are different.
 

hotrod351

Full Member
Joined
Feb 28, 2013
Messages
175
i believe the lope will come form the lope centers, 1/2" lift is a good cam. RV cam. ive always run stock cams for off roading.
 
Top