;D dynoed my 408w today.480.3 hp at 5700 rpm.not too bad running off a non tuned 750 cfm holley(shop not setup to dyno efi).torque was at 399.9 at 2600rpm torque maxed 475 at 4600 rpm.very smooth running with a nice crisp throttle response.ran best when timing set at 32 degrees.no jetting or carb work done(they used an inhouse victor jr. intake and 750 carb estimated on the jetting ) should hit 500 with proper jetting but no sense in paying for it when it`s not my carb. efi should be same hp or better.basically ran it to make sure all is well and to do a proper break in. 9.25 compession and runs like a raped ape! should be a very strong reliable motor. motor was ran under a full load to produce real #`s not unloaded dyno crate motor #`s.would probably hit closer to 600 on an unloaded dyno run.











