• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

67 drum to disc conversion

Adam7118

New Member
Joined
May 12, 2023
Messages
40
Hey guys. Can someone point me in the right direction for a write-up on a disc brake conversion for a 67 on a dana 30? I've hear the explorer option might work. Possibly a Monte Carlo/Suzuki setup. I'm told the knuckle-out conversion may not work on a 67 because of the Dana 30. I'd prefer to go with something that has a stock option so I can run to the parts store later on down the road when I need replacements.
 

Pa PITT

Contributor
Bronco Guru
Joined
Jul 15, 2005
Messages
11,300
Loc.
Stephenville TEXAS
It's on here for sure.. Because that the only swap we ever used to do. I'M not good at pulling up that old post.
Welcome aboard .
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
GM disk brake, same as the Dana 44. GM backing plates, spindles, calipers and pads. Ford rotors.
Still have to grind the knuckles a little, just the knuckles are a little different shape.
The basic spindle out disk brake conversion that has been going on for 30 years. Nothing new.
Write up should be in the tech section

Forget the Explorer/Suzuki parts for a front disk conversion.
 

thegreatjustino

Contributor
Red Head Grease Monkey
Joined
Jan 23, 2002
Messages
16,291
Loc.
Stockton, CA
The knuckles out Ford conversion will not work on your Dana 30. That will only work on a Dana 44.

The Explorer and Suzuki swaps you refer to are for rear disc brakes.

The only disc brake conversion you can do on a Dana 30 with any kind of OEM parts is the GM conversion as mentioned.

Parts List

Install Instructions
 
Top