• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Anti-wrap spring perches

t120r

Contributor
Sr. Member
Joined
Nov 25, 2008
Messages
643
Hello all, in my lifted '90 Ranger, I removed the stock 3" leaf spring perches from the rear axle. I then installed some 7-3/4" perches. The difference was night and day in regards to stopping mostly. No more wheel hop.

My bronco will be a stock height using wildhorses leafs and I may install 31s at a max tire height.

My question is: Is it worthwhile removing the stock spring perches on my '66 Bronco 9" and putting on the longer perches? Anyone ever tried?
 

Rox Crusher

Bronco Guru
Joined
Dec 13, 2008
Messages
2,830
If your not putting any high hp motor in it either, I would say not needed.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
You can try it but most springs wrap way farther out. With your tire size and stock height I'd say you probably wont have any spring wrap issues unless as stated you run a high HP/TQ motor in it and like to mash the gas pedal.
 
OP
OP
T

t120r

Contributor
Sr. Member
Joined
Nov 25, 2008
Messages
643
Well for now it will be keeping the 200I6, but I do have an eaton M90 for it. I guess I can always just leave it unpainted till the body goes back on. Then I can install the perches and set the angle.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Even with a hopped up 200 I dont really see you wrapping the springs up with your tire size. Superchargers may add power but they take power to run. Your still barely reaching the V8 power range with it.
 

Kegger

Jr. Member
Joined
Nov 25, 2011
Messages
144
Loc.
belton,Texas
Sounds like your down that far in the build, it won't hinder travel if you some day uping the engine torque / hp, your done back there, did it to mine just cause, swaped to a curie, but mine is a stroker.
 
OP
OP
T

t120r

Contributor
Sr. Member
Joined
Nov 25, 2008
Messages
643
The power aspect doesn't really concern me too much. The most benefit I noticed from my '90 Ranger was the braking. It had a tendancy of wheel hop if you hit the brakes too hard. No biggie. I'll save the housing for last to powdercoat. Thaat gives me lots of time to decide what I will do.
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Pickups are way different than broncos in there needs. The light rear end of a ranger and brakes locking up would cause spring wrap. I dont see it being the same in a bronco. Of course theres nothing wrong with using extended perches. I just really dont see much of a need for it on a stock height bronco. later on down the road if you decide to lift it they may be a good idea but then again you would be better off waiting and installing them at that time so you can adjust the pinion angle.
 
Top