• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Axle Shafts the Same?

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
Converting the Dana 30 to a Dana 44. Are the axle shafts interchangeable? I did a search and came up empty.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,114
No
The inner on the 30 has 27 splines
The inner on the 44 has 30 splines
But the outers are the same
 
OP
OP
Chief Master Sergeant

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
Converting the Dana 30 to a Dana 44. Are the axle shafts interchangeable? I did a search and came up empty.
 

cldonley

Contributor
Bronco Guru
Joined
Jul 4, 2011
Messages
1,398
Loc.
Robinson, TX
I may be crazy, but I think that is the most significant difference between the two. I remember reading that the 30 represents the diameter of the 30's shaft and the 44 likewise. Maybe in mm? Of course I could be having a senior moment! :-[
 

jim3326

Bronco Guru
Joined
Jul 12, 2010
Messages
1,781
Loc.
Appleturkey
Other than the shafts being weaker. I would think it makes more sense to upgrade than risk tearing something up if/when it breaks.

Jim W.
 

welndmn

Bronco Guru
Joined
Nov 12, 2001
Messages
2,112
Minus a few brake/hub parts, not a lot of dana 30 parts swap onto a dana 44

You need new axle shafts.
 
OP
OP
Chief Master Sergeant

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
Yeah, just plan to use the ones coming in the donor. I just replaced the joints in the axle shafts is why I asked. No worries. Joints are reasonably priced.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,114
Just a heads up on front axle joints. They are the most highly stressed joint in the truck. When they fail it is usually violent, taking out the ears of the shafts as well. This joint is very touchy about quality. The bargain parts store joint will fail much easier than a good Spicer joint will. Running cheap joints will probably cost you more money in the long run since the shafts will need replacing when the cheap joint fails. Only run good Spicer joints in the front. They are already a little bit undersized and need all the help they can get.
 
OP
OP
Chief Master Sergeant

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
Thanks brother. I always get Spicer. Haven't tried to source them here in Albuquerque yet. Thanks again
 

moses_m

Full Member
Joined
May 5, 2013
Messages
262
Sargeant doing the same upgrade as you. What tie rod and drag link are going to go with, stock or are you upgrading?
 
Top