• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Bilstein 7100 Question

75Bronc

Sr. Member
Joined
Feb 5, 2008
Messages
425
So my bronco has been siting for a while, it needed a few things. Today I put some new 7100's on the back. And took it for a 20 minute test drive. I get back and the old broke up exhaust was pointing right at one of the shocks about an inch from it. My shock was HOT! Like too hot to touch.

This was the first trip on these new shocks. Do you think I could have hurt them?? Man, what a dumb thing to have happen.

Thanks guys.
 

landshark99

Contributor
Bronco Guru
Joined
Oct 13, 2011
Messages
1,407
Loc.
Montrose, Colorado
They should be fine. Oil just thins out and is less viscous won't dampen as well until it's cooled off again. Wouldn't worry about it after just 20mins

Probably should reroute your exhaust or shield the shock
 
OP
OP
75Bronc

75Bronc

Sr. Member
Joined
Feb 5, 2008
Messages
425
I will definitely reroute the exhaust. It was only 20-30 minutes, but all of it was slow going. That shock was hot!! But I imagine those shocks are designed for sand rails and prerunners, I'm sure the internal temps get pretty hot in those applications.
 

garberz

Bronco Influencer
Joined
Jun 24, 2007
Messages
6,864
Loc.
Conejo Valley, Ca.
I don't think you got it hot enough to do damage to anything internal, that would take much more heat than your exhaust puts out.
 
OP
OP
75Bronc

75Bronc

Sr. Member
Joined
Feb 5, 2008
Messages
425
That's comforting. It was so hot it about burned my finger. Ha ha
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
They can get that hot from extended hard use too. But yes, they can overheat and you can damage the oil and the seals. But you'll see a bad seal quick enough when things that are supposed to stay inside the shock start to come outside!
And even if you were able to tell from performance that the oil was toasted (it's not likely at this point, as the others said) the 7100's can be pulled apart and the oil replaced with new.

But again, you likely are ok. You have boots on these or no? If boots, and they didn't melt, then you'd be ok.
If no boots, as said, just keep driving it and see how they roll.

Have fun.

Paul
 

ame

Full Member
Joined
Jun 28, 2016
Messages
191
If you could actually touch the shock without burning your skin then its fine, once you get 300 deg + it can damage seals.
 

ame

Full Member
Joined
Jun 28, 2016
Messages
191
I dont know which oil Bilsiten uses but deal with a lot of Kings and have seen both Bilstien and Kings hit 300 with no issues, not saying I recommend getting shocks any hotter then they need to be but if you go play in Baja it not uncommon to see shock temps pushing 300 deg. Duration also plays a large role, I have no doubt the oil could break down at 300 deg if ran at those temps for long period of time.
 
Top