Brake Conversion - Where to find Hub/Rotor

[kiteoregon]

I have been to the yard several times looking for the following:

Ford Hub/Rotor
Assembly D6TZ-1102A
Bronco 76-80
F150 76-80
F100 76

Every trip end up with the parts already pulled, or none to be found. When i look on line at the local parts houses i find the rotor and sometimes the hub, but no complete assemblies. I have found a couple that go for about $150 per, but that seems expensive.

Anybody have any insight as to where i might find this? I would like to get the hub with the bearing racees already pressed in.

Thanks.

KO.

 

[broncodriver99]

Rockauto.com and NAPA both have them. The hub alone or the assembly. I got the Raybestos hubs from NAPA for $80/ea a couple of weeks ago. Most of the Bronco vendors carry them as well. The Raybestos hubs came with preinstalled bearing races and new wheel studs as well. I already had a set of new rotors. Think they were about $35/ea. So in about 30 mins of assembly I had an all new assembly for $115/per side.

 

[broncnaz]

JBG had them for about $110 but they are out of stock. Might try the other venders prices have gone up a lot 10 years ago you could get the complete setup for $30 now its $30 for just the rotor.
Also hubs and rotors form 76-at least 92 will work(might be able to go all the way to 96 but I'm not positive on that) you only have to be careful of hubs on 86/87ish vehicles as they had a odd ball hub.

 

[kiteoregon]

broncodriver99, any chance you have the part number for the hubs? I just went to my local store, they said the hubs were 119 and did not have the races pressed, they did offer a complete assembly for 233 per side.

 

[broncodriver99]

Sure do.

The Hub/Rotor Assy. is Napa PN# NB 4886297 $188.10/ea. at my local NAPA.

The Hub only which is the same Raybestos package that rockauto lists is PN# NB 4885943 $76.50/ea. at my local NAPA

I assume you are doing the Ford disc swap. I looked up a '78 Bronco and used those numbers and everything fit perfect. Rockauto has the same parts, but by the time I figured in shipping my local NAPA beat them. YMMV

 

[broncodriver99]

The Rotors I used were from NAPA as well. PN# NB 4885611 $32.40/ea. at my local NAPA.

 

[kiteoregon]

I am going to do the chevy break conversion, i have chevy spindles and backing plates, and now some ford hubs of a 79 F150, this second yard today had a new 150 in, and i think these hubs will work. I will check the prices for getting the rotors turned, but for $30 ish, new is always a good option.

Funny, when i check prices out west, our hub/rotor is about $22 more expensive.