• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Centech install - Firewall Grommets

rflud

Bronco Guru
Joined
Oct 22, 2001
Messages
1,476
Loc.
Modesto, CA
I have tried a half dozen different ways to get the grommets (the one for the driver and passenger side) to seat in the firewall but with little effort (one finger) you can push the grommet out of the hole. I would imagine normal vibration from driving will also cause it to fall out of the hole. Anybody have any tips or tricks from when they did their Centech install?<br>
 

brokenhorse

Bronco Builder
Joined
Aug 6, 2001
Messages
1,750
Loc.
Wisconsin
Use a little silicone seal to help slide it in and they go in HARD if you drilled the right size hole,use a screwdriver a negative small purpose to work the gromet into the seating chanel of the gromet.HTH
 
OP
OP
R

rflud

Bronco Guru
Joined
Oct 22, 2001
Messages
1,476
Loc.
Modesto, CA
The holes are the factory holes for passing wiring from the engine compartment to the dash so I would suspect that it's the right size. Also, the hole is not just a whole is has a lip on it that in my opinion is keeping the grommet from seating.

I thought about wedging it in there and then getting some black silicone to hole it in place. That should work, right?
 

LSUpete

Contributor
Bronco Guru
Joined
Jul 11, 2001
Messages
2,065
I know exactly what you're talking about. My firewall holes had a little lip on them, so the Centech would NEVER have seated properly. So, I cut the Centech grammets off and used my orignal grommets.
 

jims66

Sr. Member
Joined
Jun 25, 2001
Messages
961
Use 3M weatherstrip adhesive, it's meant to hold rubber to metal. Silicone will have a hard time bonding to rubber.
 
Top