The y setup is parallel with the stock TB. It appears to have a 3" drop pitman arm?
But parallel is slightly different from a T style. Note savage's setup with no modification. The "draglink" on the Y setup is much longer than the original, where the normal parameters apply. Which are length, plane and parallel. In the case of the Y the lengths are all different.
Apples to oranges...
The TB mount is stock on the axle side and I was questioning the frame mount since it lines up with the drop pitman arm.
But it doesn't actually. It lines up nicely to our eyes, but it's still off from original.
I'm working on replacing the entire suspension with a 3.5" which is what appears to be on it now.
I'll be swapping to the WH T setup and adjustable track bar (sitting in my garage), but as the truck sits i have absolutely no bumpsteer or death wobble.
So don't do anything else to this setup, as you are going to be changing to the T setup at some point. Since it's not giving you any bump-steer trouble, don't sweat it. It would never cause a Death Wobble anyway. That's from other things.
Keep the existing dropped pitman arm, keep the stock upper trackbar bracket (do NOT use a drop bracket when you put the T system on) and see how it all works together at that point.
You will likely need a tapered shim to go into that pitman arm. It probably has one now, but you should double check when you get it apart and if you do have one, don't toss it out.
I just hate these Y setups. haha!
How come? Well, they do have their weaknesses, and they usually come out when you lift the vehicle and run larger tires. So if that's the case, then they're not the best choice. But when left stock the Broncos (and F150's) that used the Y setup had VERY good street manners for the most part.
Larger tires alone can mess that up, especially off road. But add a lift too and some things go south pretty quickly.
Paul