Dana 20 Front Output shaft - T-Type

[tmbonnett]

I'm looking for a front output shaft for a 69 Dana 20 Transfer case (T-Type). Does anyone know if I could use one from another vehicle that was equipped with a Dana 20?

Thank you,

Trent

 

[sykanr0ng]

The front output shaft is one of the parts that does interchange between the Bronco Dana 20, the Scout Dana 20 and the Jeep Dana 20 - but they are J shift type shafts. Some of those shafts are 26 spline instead of the Bronco's 10 spline.
You can replace a T shift front output shaft with a J shift front output shaft, and it gets rid of the snap ring that makes removing the front shaft so much of a pain.

 

[tmbonnett]

Thank you for the info. So if I locate a 10 spline front output shaft from a Jeep or Scout(which are J type) it will work?
It appears that the snap ring was what caused me to damage by original shaft.


Sent from my iPhone using Tapatalk

 

[sykanr0ng]

You will need the front output gear washer for a J shift also, it is larger because of no snap ring.

 

[Viperwolf1]

2 special spacers are needed with the J shaft.

 

[tmbonnett]

I was able to locate a t-shift front output shaft. Unfortunately, I broke the snap ring and can’t seem to locate one.
Any help would be greatly appreciated.

Trent
407.276.0228


Sent from my iPhone using Tapatalk