• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

distributor drive pin sheared

metal1

Full Member
Joined
May 2, 2016
Messages
260
Loc.
hidesert ,socal
Having a blast deriving the 67 out at the off road races in lucurn valley hit a big hole and the engine died pulled it back to camp very weak spark tried all new parts in the dist. Still barely a spark ,trailered it home .damm it ,the dist. Is the gm hei top then machined for a ford we run the same one on our norra truck .after playing with it for a few days turned the dist and it fired right up ,let it run for an hour to charge up the battery .pulled the dist out and sure enough spun the roll pin ,now to replace the pin
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
Check the oil pan for dents. You may have bashed the axle into the oil pan hard enough for the pan to have kissed the oil pump. Flexing the oil pump to the point of binding up.

Are you running a high volume oil pump? Those are also known for placing extra load on the oil pump drive and distributor gear.

What brand is the distributor? Some are well known for breaking. But differently from what you experienced.
 

Digger556

Sr. Member
Joined
Aug 8, 2013
Messages
801
I would repeat what Broncobowsher said and add that the distributor gear should be a slight press fit on the distro shaft. If loose, it can wear through and shear the roll pin.
 

blubuckaroo

Grease Monkey
Joined
Jun 11, 2007
Messages
11,796
Loc.
Ridgefield WA
Most distributor pin failures are a result of oil pump issues.
Sometimes the oil pump extension shaft twists, sometimes the distributor gear pin fails.
It can be a broken pump, or sometimes engine builders select too much pump.
 

svobronco

Contributor
Sr. Member
Joined
May 31, 2011
Messages
350
Had one sheer in a 400M- extreme cold and heavy oil. Didn't make it to work that morning.
 

ntsqd

heratic car camper
Joined
Jan 30, 2005
Messages
5,970
Loc.
Upper SoKA
OEM Ford pin is a spiral. Aftermarket & rebuilders sometimes use just a std. roll pin, which looks like a 'C' with opening nearly closed up. Pretty common failure mode well known to experienced racers. They take a second roll pin that fits inside of the first one and install it with the gap facing 180° from the first one.
 
Top