• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Distributor for 351W

JdubO

New Member
Joined
Dec 28, 2019
Messages
4
In the process of rebuilding a 351W in a '74. Purchased MSD Ignition 83541 Ready to run distributor. Installed engine and have hood clearance problem with the new distributor. Truck has stock suspension, lift, wheels, etc. Any suggestions on comparable replacement distributor that will provide clearance?

Thanks
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Hey Jdub0. Sorry to hear you're having a problem. It's a bit of a tall distributor, on an already taller engine. But not by that much in the distributor department I would not think.
Wondering if a stock Dura Spark would be any lower. Looks like it, but not sure. And then you're into all the wiring again rather than a simple one-and-done kind of a setup. Well more like two wires probably, but you get the point.

A body lift is the most common solution for either a too-tall distributor (even on a 302), or most 351 installs as well. A 1" body lift is the compromise for added lift without too much bumper/body gap.
Do you know exactly how much clearance you need? Unfortunately there's that hood cross-brace right there that gives us so much trouble when choosing distributors. But a 1" body lift is the usual solution.

Any resistance to a body lift? Some will cut the brace, but I'm not a big fan of that at all.

Good luck. Hopefully someone else has run into the same combination issue and had a nice clean cure.

Paul
 

TNcowboy

Full Member
Joined
Aug 29, 2019
Messages
220

Attachments

  • PNG image.jpg
    PNG image.jpg
    75.7 KB · Views: 102
Last edited:
OP
OP
J

JdubO

New Member
Joined
Dec 28, 2019
Messages
4
Hey Jdub0. Sorry to hear you're having a problem. It's a bit of a tall distributor, on an already taller engine. But not by that much in the distributor department I would not think.
Wondering if a stock Dura Spark would be any lower. Looks like it, but not sure. And then you're into all the wiring again rather than a simple one-and-done kind of a setup. Well more like two wires probably, but you get the point.

A body lift is the most common solution for either a too-tall distributor (even on a 302), or most 351 installs as well. A 1" body lift is the compromise for added lift without too much bumper/body gap.
Do you know exactly how much clearance you need? Unfortunately there's that hood cross-brace right there that gives us so much trouble when choosing distributors. But a 1" body lift is the usual solution.

Any resistance to a body lift? Some will cut the brace, but I'm not a big fan of that at all.

Good luck. Hopefully someone else has run into the same combination issue and had a nice clean cure.

Paul
Paul, I don't visit the forum much...maybe that will change. I realized I never replied to you. Decided on the 1" lift. That has resolved the distributor issue. Thanks for the reply. Now having the tranny rebuilt.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Great! Thanks for the follow up.
That really helps when someone else has the same question and sees this discussion.

Have fun!
 
Top