• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

EFI Speed Density Harness

Madgyver

Bronco Madman
Joined
Jul 30, 2001
Messages
15,030
Is this all I need from the donor vehicle (pic)?

Do I need to pull the main harness with the fusebox also?

I hate to get rid of the stang If I need more of it.

I got the engine harness and everything connected to it, harness to the EEC, harness to the VSS but it goes through the main harness, Inertia switch..

What else?
 

Attachments

  • efi harness SD-copy_edited.jpg
    efi harness SD-copy_edited.jpg
    118.9 KB · Views: 98

COBlu77

Sr. Member
Joined
Feb 10, 2004
Messages
867
Loc.
Arvada, CO
You will want the sub-harness that connects to the harness in your picture and plugs into the O2 sensors and also the section of the main engine harness that has all the injector connections along with the ECT, ACT, TPS sensors.

I don't think you will need the chassis harness that has the fuse box on it, but remember that the chassis connectors (grey/black/brown and green) won't have the same wire colors as listed on the www.fordfuelinjection.com web site. You will want a wiring diagram for the vehicle you got that from. I tried to convert a 91 Mustang harness to match Ryan's design. I traced every wire back to the ECM and then tried to make a cross reference to the colors listed on the www.fordfuelinjection.com diagrams. I then labeled every wire with masking tape. It was very tedious and the diagram for the specific vehicle would have made life much easier. On the other hand, I really understood what was what when I put it back together.

If I was going to do it again, I probably wouldn't try and convert it to Ryan's design. I'd keep it all intact and just make the appropriate connects to your Bronco harness, ground , 12v, run, and start.

The temp and oil pressure wires on the harness in your picture are easy to splice into your Bronco guages. The wire colors should even match. Then you just need to find the run, start wires for your Bronco harness.

BTW after trying it several ways, it runs much better with the EGR, CANP, and AIR sensors hooked up instead of trying to eliminate or trick the sensors with diodes.
 

SaddleUp

Bronco Guru
Joined
May 23, 2004
Messages
9,655
Loc.
Vancouver, WA
I've tried it both ways. I.E. Stock vehicle and also wired by Ryan's diagrams. I can concur with it being easier to just stick to the vehicle diagram. It definately wasn't worth rewiring everything just to add a separate relay for the O2 sensors.

I would skip the temp and oil connections if you already have them in your EB. They don't lead to the ECM in any way and therefore don't need to attach to anything.

EGR, CANP, and the TAB/TAD soleniods shouldn't effect performance at all. The exception is that the ECM needs to know if the EGR is opened or closed. I haven't had any of them hooked up in 2 1/2 years and mine runs great. (It runs better than my bone stock 89 F250) I did run to Radio Shack and get the resistors to keep the light from coming on for them and to let the ECM know the EGR is closed/removed.
 
Top