ilovemaui
Bronco Guru
I finished my install last weekend and today I was going to fine tune the timing. The engine fired right up and ran smoothly. I disconnected the spout and plugged in the timing light. It started right up again and I proceeded to rotate the distributor a little. I could tell it needed to move clockwise so I turned off the motor and rotated the distibutor a little. Then when I tried to start it cranks but does not start. I put the distributor pretty much back where it was but still no start. Very strange that it was running very nicely and then bam, no start.
I checked the codes and all I get are 81, 82, 84 and 85. I have a fuel pressure gage on the fuel rail and I'm sitting at just about 40 psi. I'm stumped.
I checked the codes and all I get are 81, 82, 84 and 85. I have a fuel pressure gage on the fuel rail and I'm sitting at just about 40 psi. I'm stumped.