It's been quite a while since I've updated you guys, I haven't been on much at all. I've just been taking care of odd ball projects I've had and have been spending time with my wife. She's even managed to get this old fat guy to go to the gym with her on a semi regular basis.
So, first some good news... All of the wife's tumors (yes, they've found more) are benign! That doesn't mean that we are out of the woods, she still has really high white blood cell counts and some other issues with her blood work that they can't seem to figure out a cause for. They keep tossing around bone marrow biopsy as a possible next step. But, we'll take any good news we can get at this point. This whole thing has been so stressful on both of us that we came very close to splitting up. Fortunately we didn't and things are now going better than ever. I just want to thank you all for the prayers and positive vibes, they seem to be working so far!
So, I think I'm about a month out from taking in harnesses again. The current project I'm working on is shoehorning what may be the worlds biggest ESD workbench in to the worlds smallest home office. As if that wasn't a big enough challenge, I'm also adding linear actuators to it in an effort to save my back while working on harnesses. At least I won't freeze or sweat in the garage and no more being hunched over the dining room table when the weather is bad.
Once I'm done with that, I'm going to do 2 harnesses for my own personal projects and then I'll start taking harness orders. I know there are a few people in line already so new harness orders aren't likely to start shipping until April or so.
In an effort to maximize my free time (wife time) I'm going to do a few things a little differently. One of which will be asking you guys to strip all of the tape off from your harness before shipping it. It's time consuming and tedious but it's easy and I'd rather focus on the technical stuff. I'm also going to try and minimize my junkyard time so I'm going to ask that you provide any connectors that you want replaced. Most can be found in other cars, just clip em and ship em, I'll replace them.
Also, I'll probably offer 3 different harness options. One would be where I just do the firewall harness and send you the materials to do the engine harness. Again I'd do the technical stuff and let you do the easy side by following the videos. Another would be where I'd do both harnesses and let you wrap it. The the final would be the complete re-work and re-wrap. I'll figure out pricing when I get closer to taking in orders again.
Thanks again to all of you!
