Nightstick
Bronco guy
- Joined
- Feb 6, 2010
- Messages
- 2,929
I'm fixin to weld on the front towers and just wanted to know who followed Jon's advise from the tech article and straightened the towers out by cutting, bending, and rewelding them. If you didn't are the tires contacting the shock, and if you could do it over again, would you do like Jon said?
Also, in my infinite wisdom I didn't mark the mounting point before I cut the old ones off. Did you just line up the bottom bolt holes and weld them on, then measure for the driver's side, or is there a better way of getting a more precise mounting point?
Also, in my infinite wisdom I didn't mark the mounting point before I cut the old ones off. Did you just line up the bottom bolt holes and weld them on, then measure for the driver's side, or is there a better way of getting a more precise mounting point?











