Millercorey
Full Member
- Joined
- Mar 15, 2017
- Messages
- 232
Tearing out old floor pans to weld in new, and when I got to the 2nd passenger support it looks almost...bent??? I'm not sure how it happened, if I should cut out and replace with a new one, and the impacts that may have.
Take a look at the pics and let me know your thoughts. My big concern is if this thing is truly bent down by a small bit, then that means the right side of my bronco is hanging low. If I wanted to replace with a new straight support, I guess I would have to jack up that side of the body before I welded in the new support and support brace to make sure everything lined up?
My big concern is that this is a symptom of a FAR greater problem. FYI - the holes in the dash to screw in the windshield support don't line up correctly. Almost like the dash is 1/8" too low on the passenger side. I'm not sure if that's connected (meaning my entire right side has dropped 1/8").
On the flip side, you probably can't see it in pictures, but it almost looks like the body support has kind of "dimpled" up through the support, which if that's the case, makes me feel better about what I'm seeing here.
Either the support comes out from the centerline nice and straight and then bends down towards the exterior of the body (WORST CASE)
OR
Everything has kind of sagged down around the body mount creating kind of a reverse of the dimple you see in the floor pan. (SEEMS LIKE A BETTER PROBLEM TO HAVE)
Take a look at the pics and let me know your thoughts. My big concern is if this thing is truly bent down by a small bit, then that means the right side of my bronco is hanging low. If I wanted to replace with a new straight support, I guess I would have to jack up that side of the body before I welded in the new support and support brace to make sure everything lined up?
My big concern is that this is a symptom of a FAR greater problem. FYI - the holes in the dash to screw in the windshield support don't line up correctly. Almost like the dash is 1/8" too low on the passenger side. I'm not sure if that's connected (meaning my entire right side has dropped 1/8").
On the flip side, you probably can't see it in pictures, but it almost looks like the body support has kind of "dimpled" up through the support, which if that's the case, makes me feel better about what I'm seeing here.
Either the support comes out from the centerline nice and straight and then bends down towards the exterior of the body (WORST CASE)
OR
Everything has kind of sagged down around the body mount creating kind of a reverse of the dimple you see in the floor pan. (SEEMS LIKE A BETTER PROBLEM TO HAVE)











