• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Flush mount windshield

Snackslinger

New Member
Joined
Jul 16, 2020
Messages
44
What have you guys done to finish the inside when you install a flush mount windshield?
The gap and seeing the glue does not look good.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Got a picture?
I always wondered about that aspect, but I assumed that the first step was probably to at least smooth down the metal edge.
No idea what anybody’s using to cover the glue though.

Good luck
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
If the sealant in that link looks like yours, I can say that the installer would have done well to at least try to smooth it out rather than leave it wavy.
I wonder if something similar like simply applying a new coating of silicone on top of the old, and then simply tooling it flat would be enough.
 

Mark1911

Full Member
Joined
May 14, 2017
Messages
174
I will be following along, I am also considering a flush glass.

Mark
 

armynavy17

Contributor
Sr. Member
Joined
Jan 9, 2010
Messages
361
It depends how "flush" you want it to look from the outside too. If I remember correctly the process was to lay a thick enough bead of sealant that the glass is just proud of the surface of the frame. If you set the glass in a little further, there would be less of a gap to clean up and see.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Seems like the best practice would be to reform the metal windshield frame in the first place. Creating a more shallow channel for the windshield and glue to set up in.

In lieu of that though, you could probably create some kind of molding in the form of a frame to fit around the entire perimeter covering the glue. It could literally take the form of anything that you think would look good there. From painted aluminum to plastic to something that you used a 3-D printer for.
Of course, the first thing that comes to mind is interior door molding for a house! :) Ha ha!🙄
 
Top