• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Front Springs

Fastimz

New Member
Joined
May 13, 2019
Messages
8
I have a set of front springs that measure right at 17.1" unsprung. This is my 71 that I have disassembled to the frame, so I can't measure frame to axle with the engine and drivetrain out. Any idea if these are stock springs or any lift to them? Thanks in advance.
 

jckkys

Contributor
Bronco Guru
Joined
Mar 15, 2012
Messages
5,221
You need to know more information. For instance what is the wire diameter and the lbs./inch compression rate?
 

jckkys

Contributor
Bronco Guru
Joined
Mar 15, 2012
Messages
5,221
I looked at the TRW spring specs and found the TRW EB coil is only 16.3" free length. So if yours is a similar rating, it would give you a 0.8" lift. I don't know of an after market coil like that and '78/'79 Bronco coils have a 17.5" free length. So it's unlikely for '78/'79s.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
Impossible to tell. Free height means almost nothing. If those are really stiff aftermarket springs, that could be about what the installed height is. If they are really soft springs, and you have a heavy rig, it could be lower than stock.

referencing off another spring's free height only works if you know the spring rate is the same. For the past 20 years the spring rates are generally very low, as compared to 20 year before that where they were very high, and stock was somewhere in the middle.
 
Top