KyleQ
Bronco Guru
- Joined
- Apr 24, 2008
- Messages
- 5,480
The joints may be independent of each other, but they are connected via the steering. Phasing the joints avoids the lumpy offset you can get if the joints are not on the same plane as eachother. I've run my truck with the joints out of phase and it sucked - I lost steering axle and I could tell the joints were always loaded.
Then again this is on a D60, fully welded with full hydro steering - YMMV
Then again this is on a D60, fully welded with full hydro steering - YMMV
Last edited: