doghows72
Bronco Guru
- Joined
- Jan 5, 2005
- Messages
- 2,036
I figured I'd better put this in its own thread so here is the process I used to make my rear window for my Bronco Designs Half Cab.
I started with a slider from an 86 Ford Ranger. It has the same arch to the top as the half cab does. The ranger window is a lot taller but narrower in width.
So first things first was to disassemble the window. Pretty straight forward to do, a couple screws and pull out all the rubber seals.
I cut it down to get the top to bottom fit and clamped it all up.
I started with a slider from an 86 Ford Ranger. It has the same arch to the top as the half cab does. The ranger window is a lot taller but narrower in width.
So first things first was to disassemble the window. Pretty straight forward to do, a couple screws and pull out all the rubber seals.
I cut it down to get the top to bottom fit and clamped it all up.
Last edited:











