Bronco-Brian
Full Member
I've been unhappy for years running bulk heater hose to the heater core at the firewall and dealing with sloppy hose routing. Finally found a clean solution I thought I'd share with others. I spent 15 minutes with the O'Reilly's auto parts kid and found a molded hose p/n that fits the bill nicely. Checkout Gates 18836 molded hose.
You will need to cut off the last 3" of the double 90 deg bend end and I route that side near the valve cover. The 90 degree bend at the heater core is perfect for early Bronco inner fender clearance. See pics below. The inboard hose runs to the heater valve (perfect length), and the other hose uses a 5/8" barbed union. From the heater valve and the union to the intake and water pump, I just use bulk 5/8". Way cleaner install than I've ever had in the past.
You will need to cut off the last 3" of the double 90 deg bend end and I route that side near the valve cover. The 90 degree bend at the heater core is perfect for early Bronco inner fender clearance. See pics below. The inboard hose runs to the heater valve (perfect length), and the other hose uses a 5/8" barbed union. From the heater valve and the union to the intake and water pump, I just use bulk 5/8". Way cleaner install than I've ever had in the past.











