High Beam Foot Switch Measurement

[72_EB]

Just put some new floors in my project and may as well put it where it goes. Anyone got a stocker that they can measure? Pretty cheesy to ask where to drill this into the floor, but may as well do it right while I'm here.
TIA.

 

[Mark]

speaking of cheesy...
I mounted my switch onto a flat magnet that sticks to the floor.
Looks good actually, no holes (rust starting points), and adjustable.
It's strong too, doesn't move.

 

[jkskier]

I have 7.25 inches up from the bottom bend, and 2 1/16th inches towards center from the inside wall. This is for the medial of the two holes.

 

[DirtDonk]

I moved mine from the stock location a long time ago because it was always just a bit awkward to get my foot on it in a hurry. The parking brake pedal was always the first thing to hit.
You might just double check that angle and move it a bit inward just in case. Doesn't take much, but I'm mucho happier with it now. And since you're starting fresh, hopefully your wires will cooperate.

Paul