• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

High Torque Starter Swap

EarlyElway

Jr. Member
Joined
Dec 11, 2012
Messages
58
Loc.
Shawnee, KS
My OEM starter recently went out and i purchased the high torque starter from TBP and the actual install was very easy, it's the wiring I'm concerned about at the solenoid. The instructions say to move the starter cable to the opposite post on the solenoid. I did not follow these instructions correctly initially and the truck started but new starter seemed to stay engaged and I quickly shut off the motor and disconnected the battery. I went back to the instructions and tried to rewire the correct way but I'm getting nothing when I turn the key. I'm hoping I just fried the solenoid and I have purchased a new one but before I reinstall I was hoping to get some feedback. My solenoid has more wired to it on the postive terminal than just the cable going from the batter and I'm not sure waht it all does with the exception of the radio. I just want to make sure I have it all wired correctly before I hook the battery back up to the new solenoid. Any help would be greatly appreciated.
-Matt
 

broncodriver99

Bronco Guru
Joined
Jan 27, 2008
Messages
4,780
Loc.
Glen Allen, VA
Yes, you need to move the heavy gauge wire that goes to the starter to the always hot lug of the solenoid. You then add/wire a/the small wire that goes to the solenoid on the starter to the switched side of the solenoid on the wheel well where the starter heavy gauge cable used to be. The reason is as the starter spins down it becomes a generator and will produce enough power to keep the solenoid on the starter engaged. Try tapping on the starter with a rubber mallet or dead blow hammer. You may have jammed the drive up when it stayed engaged. Also, recheck your electrical connections. You could have broken a wire or made a poor connection when pulling everything apart to rewire it.
 
OP
OP
E

EarlyElway

Jr. Member
Joined
Dec 11, 2012
Messages
58
Loc.
Shawnee, KS
Yes, you need to move the heavy gauge wire that goes to the starter to the always hot lug of the solenoid. You then add/wire a/the small wire that goes to the solenoid on the starter to the switched side of the solenoid on the wheel well where the starter heavy gauge cable used to be. The reason is as the starter spins down it becomes a generator and will produce enough power to keep the solenoid on the starter engaged. Try tapping on the starter with a rubber mallet or dead blow hammer. You may have jammed the drive up when it stayed engaged. Also, recheck your electrical connections. You could have broken a wire or made a poor connection when pulling everything apart to rewire it.

Thanks for the advice. One more question.

What about the other wires that were orignally installed on the hot side? Should they stay there or should they move? As I understand what you are saying now is the cable to the starter and the positive cable from the battery should be on the same side solenoid terminal, what I'll call passenger side, and the new small wire should be on the wheel weel(driver) side solenoid terminal?
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Yes to that.
There should be a large gauge Black wire there that powers up the whole truck. On '74 and later models there is a medium gauge Yellow wire for the horn relay.

Then the starter cable now of course.

Any wires other than those are likely added afterwards. You mention radio, but Ford did not put a radio wire there. Only aftermarket setups.

When in doubt, take a picture of what you have and we can look it over.

Paul
 
OP
OP
E

EarlyElway

Jr. Member
Joined
Dec 11, 2012
Messages
58
Loc.
Shawnee, KS
Got it running, I think the solenoid was bad and incorrectly wired.

New high torque starter is a great upgrade FYI.
 
Top