EarlyElway
Jr. Member
My OEM starter recently went out and i purchased the high torque starter from TBP and the actual install was very easy, it's the wiring I'm concerned about at the solenoid. The instructions say to move the starter cable to the opposite post on the solenoid. I did not follow these instructions correctly initially and the truck started but new starter seemed to stay engaged and I quickly shut off the motor and disconnected the battery. I went back to the instructions and tried to rewire the correct way but I'm getting nothing when I turn the key. I'm hoping I just fried the solenoid and I have purchased a new one but before I reinstall I was hoping to get some feedback. My solenoid has more wired to it on the postive terminal than just the cable going from the batter and I'm not sure waht it all does with the exception of the radio. I just want to make sure I have it all wired correctly before I hook the battery back up to the new solenoid. Any help would be greatly appreciated.
-Matt
-Matt











