A couple base measurements might be very helpful in determining your issue.
What is your initial timing set at? What is your vacuum reading when truck is at temperature at a standing idle?
You can't really guess what your timing is set at without checking it with a timing light. You can listen for pinging and detonation, but really better to know where you at with an accurate instrument reading. Buy a timing light if you are going to be working on it. If you're backfiring at all, you need to check your timing. You may be running rich because you blew a power valve in the carb. This is rarely happens, but it does happen.
A vacuum gauge is also a very good tool to have as well. A good carb mechanic can adjust idle mixtures screw by listening to the sound of the motor, but a vacuum gauge makes this procedure much easier and accurate.
This is engine timing and carb adjustment. There may be other issues going on if the previous mechanic was using glass filters, installing the carb without a good gasket or insulator, failed to tighten hoses and the carb is sucking air, a failing gas cap. Refreshing to see someone with enthusiasm to work a carb, but check all the your basics first before messing with the idle mixtures screws. This will be pretty much your last adjustment.