• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

How does this go back together?

WyleCoyote

Bronco Guru
Joined
May 2, 2002
Messages
1,739
Don't forget to check and make sure your driveshaft u-joints are in phase. Here's a pic of what I'm talking about.

and a link explaining it............
Phase Explanation

And as you can see from the picture, if they are out of phase the drive shaft will be all rusty and look bad, if they are in phase it will be shiny and new! ;D
 

Scoop

Contributor
Bronco Old Fart
Joined
Feb 1, 2006
Messages
11,122
Loc.
Cuchara, CO
Testimony for Search Function!

I recently developed a slight vibration which then became a grinding noise only when backing up when braking! I thought the sound was rear brakes, but both sides looked good when I took the drums off. I then looked at the driveshaft and sure enough one of the u-joints in the CV joint was bad. I then bought the 3 u-joints to rebuild the entire shaft and then got to looking at the CV joint. I was not sure how it came apart. I was about to post a new thread to ask if anyone had done this before and how tough it was. I had the thread partially written when I thought, hell why don't I search for it? I did and found this thread which answered all my questions.

Thanks Dan for asking the questions first, and thanks Doc for the writing the BD article on this! I do have the Harbor Freight u-joint/ball-joint press so I did not need to use the hammer and socket method! Only problem I had was the big ball - I could not get it out! So I returned the rebuild kit for the assembled ball unit. Then everything went together great.

The Bronco (my 74 Rager) drives smooth again!
 
Top