Testimony for Search Function!
I recently developed a slight vibration which then became a grinding noise only when backing up when braking! I thought the sound was rear brakes, but both sides looked good when I took the drums off. I then looked at the driveshaft and sure enough one of the u-joints in the CV joint was bad. I then bought the 3 u-joints to rebuild the entire shaft and then got to looking at the CV joint. I was not sure how it came apart. I was about to post a new thread to ask if anyone had done this before and how tough it was. I had the thread partially written when I thought, hell why don't I search for it? I did and found this thread which answered all my questions.
Thanks Dan for asking the questions first, and thanks Doc for the writing the BD article on this! I do have the Harbor Freight u-joint/ball-joint press so I did not need to use the hammer and socket method! Only problem I had was the big ball - I could not get it out! So I returned the rebuild kit for the assembled ball unit. Then everything went together great.
The Bronco (my 74 Rager) drives smooth again!