I'm missing this brace / bracket

[ObscureMachine]

Mine was rusted through.

Where can I get one? I've looked at the vendors and haven't found anything.

Just fab one up?

Thanks - Jim

 

[AZ73]

Can't help you, but nice work on the frame!

 

[stlbl]

I used a piece of galvanized unistrut. Gorgeous frame!

 

[bronkenn]

If you're going to use different seats than I don't think you'll need that. Ken

 

[ObscureMachine]

but nice work on the frame!

Not my frame

 

[Skiddy]

Not my frame

well then I was going to say the long arm bolt is loose or the weld on the bracket to frame is off center a little;D

 

[DirtDonk]

Yep, anything you want. Flat plate, uni-strut, c-channel, whatever. Just put the new threaded nut-plate wherever you need it to be for your seats and/or belts.

You could also call Dynacorn this week and see if they have anything like that, or are contemplating it. Since I'm assuming they come with them on their new floor pans, they are at least manufactured. But Dynacorn is known for not caring, or even knowing how to obtain just a single piece from an assembled component they get from China.
They would not even sell the roof struts separately, even though they're part of a kit of individual, un-welded parts!

Too much paperwork trouble most likely. I bet they even have a few scraps of them left laying around from damaged kits. Probably throw out all the cool stuff we need because it costs too much to let it take up space in their warehouse.
Just like it should be... Unless you're at this end of the equation!

Paul

 

[ObscureMachine]

well then I was going to say the long arm bolt is loose or the weld on the bracket to frame is off center a little;D

Oh, I'm sure that's true on mine. Plus LOTS more! You coming over to help point stuff out for me???;D ;D ;D

 

[Skiddy]

Oh, I'm sure that's true on mine. Plus LOTS more! You coming over to help point stuff out for me???;D ;D ;D

I probably could, but you would make me use the grinder too;D