Really basic question but I’ve never had to deal with this before...
I’m about to install a 2 piece fuel pump eccentric on a roller motor. I picked up Comp Cams kit, it’s got the bolt hole and a tab to hold it in place. Does the tab go into the dowel hole for the cam? I assume it does but want to be sure as I am surprised that I cannot find the answer online.
The tab is slightly smaller than the dowel hole. I assume that is ok?
I’m about to install a 2 piece fuel pump eccentric on a roller motor. I picked up Comp Cams kit, it’s got the bolt hole and a tab to hold it in place. Does the tab go into the dowel hole for the cam? I assume it does but want to be sure as I am surprised that I cannot find the answer online.
The tab is slightly smaller than the dowel hole. I assume that is ok?











