• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Installing fuel tank

johnbeck

Sr. Member
Joined
Aug 11, 2015
Messages
534
I'm installing a standard(13 gallon?) rear fuel tank and the tank fill. Which order is the easiest: install the tank fill, hoses attached first, or install the tank, then the tank fill and hoses? I installed a one inch body lift so new hoses need to be cut to length. Is there a specific lubricant to use on the rubber of the tank fill's gasket and on the fuel line and vent line - a lubercant that won't deteriorate rubber? (I hate to ask such basic questions like "the right lubercant" but a large percentage of employees I've encounter at O'reilley's and like stores don't have the answers or often will suggest something they think could just possibly work). Thanks
 

73azbronco

Contributor
Bronco Guru
Joined
Nov 11, 2007
Messages
8,782
Attach hose to tank and then angle that thing up over the frame, sliding the hose onto filler section. I just use water as lube. Soapy if you must. Nothing else. You can usually get a good measurement of how long by measuring filler tube to inside frame rail, then add on the distance inside frame to edge of tank.
 
OP
OP
J

johnbeck

Sr. Member
Joined
Aug 11, 2015
Messages
534
I'm putting the fuel tank back in, but it will cover over two 5/16th bolt holes on the left inside frame rail. The holes, are both 3/4s of an inch back from where the inside shock mount strap is,(5 inches back from the frame crossmember). I'm guessing these threaded holes might have been from a factory muffler hanger. Should I bolt a strap of metal hanging down for the muffler shop to weld on to? Thanks
 

904Bronco

Contributor
Bronco Guru
Joined
Sep 28, 2004
Messages
6,720
Loc.
San Martin, CA
I'm putting the fuel tank back in, but it will cover over two 5/16th bolt holes on the left inside frame rail. The holes, are both 3/4s of an inch back from where the inside shock mount strap is,(5 inches back from the frame crossmember). I'm guessing these threaded holes might have been from a factory muffler hanger. Should I bolt a strap of metal hanging down for the muffler shop to weld on to? Thanks

Theses holes? Ford had an "L" Bracket for the muffler. Something similar on the outside of the frame, between bumper and shock mount for the tailpipe hanger...
 

Attachments

  • Muffler hanger.jpg
    Muffler hanger.jpg
    134.7 KB · Views: 174
OP
OP
J

johnbeck

Sr. Member
Joined
Aug 11, 2015
Messages
534
Thanks 904, I have that bracket for the right rail. rThe holes in question are on the left inside rail 5 inchs back of the rear cross member in the fuel tank area. Putting the fuel tank in will elemenate access to the holes if I want to install a hanger of some sort.
 
Top